Tawa stayed largely rural until just before the Second World War and was subdivided for housing after 1945, with state housing subdivisions at Kenepuru and Hampton Hill in the late 1950s and early 1960s. By the mid 1950s more people lived on the hilly sides of the valley or in Linden than on the old valley floor. Infill housing has since added homes as owners of older quarter acre sections subdivide. Some homes in Tawa can connect to the Powerco natural gas network and others run on LPG bottles. We check which supply suits the property, confirm it can carry every appliance you want to run, and only then start installing.
Tawa gas fitting for post-war homes, valley sides and infill sections
Most of Tawa's housing went up after 1945, including the state housing subdivisions at Kenepuru and Hampton Hill in the late 1950s and early 1960s. Those houses are now sixty to eighty years old and were rarely built with gas in mind, so adding a hob or gas hot water normally starts from scratch: a new meter if Powerco's main is in the street, or a bottle station if it is not, with fresh pipe under the floor to each appliance.
Since the mid 1950s more of Tawa's people have lived on the hilly sides of the valley than on the flat floor, and the two settings play out differently. On the valley floor, runs are usually short and level. On the hillsides, the meter can be well below the house, cylinders have to be carried up steps or a steep drive, and exposed sites can be windy; one Tawa property's LIM records a Very High wind zone. There we secure bottles with chains, fix pipe firmly and choose flue positions that suit the exposure.
Infill is common where owners have subdivided old quarter-acre sections. A new rear house may need its own supply, and the route past the original home needs to be agreed and protected from vehicles on a shared driveway. Where we can, we lay that pipe before the driveway is poured, so nothing has to be dug up later.
Local tip: If you are subdividing a Tawa quarter-acre section, plan the gas route to the new house before the shared driveway is laid.
Gas Fitter in Tawa: Local Factors
Plenty of state houses never had gas, so a hob or gas hot water usually starts with a new supply. We plan the bottle or meter position and the pipe route so it stays tidy on the outside and meets the clearance rules.
For anything else, see our plumbers in Tawa.
How We Handle Gas Fitter in Tawa
Before we arrive, clear a path to the gas meter or bottles and to where the appliance goes. If you smell gas at any point, get everyone outside and call your gas supplier's emergency number from a safe distance.
Pricing: quotes are free, and every job gets a fixed price before we start, so there are no surprises on the invoice.
Gas Fitter Jobs We Do in Tawa
- Install gas hot water
- Gas line extension
- Flued gas heater installation
- Connect gas hob
- LPG bottle installation
Gas Fitter Tawa FAQs
Our Kenepuru state house has never had gas. Where do we start?
Start with Powerco's address checker to see if a main runs past. If it does, we run new pipe from the meter to each appliance. If not, LPG bottles placed to the clearance rules are the alternative.
How much does gas fitting cost in Tawa?
Bigger jobs, such as a new supply line or several appliances, are priced once we have looked at the work.
Is natural gas available in Tawa?
Powerco runs the natural gas network across Wellington, the Hutt Valley and Porirua, and its address checker shows whether your street can connect. Kāpiti is not in Powerco's listed areas, so homes there usually use LPG.