Before the Second World War, urban settlement in the lower Hutt Valley was concentrated around central Lower Hutt, Petone and Eastbourne. In the late 1940s new state housing suburbs spread along the eastern side of the valley from Waiwhetū to Taitā, and Waterloo today has a mix of state and private housing. Housing later climbed the western hills at Normandale and Kelson. Our certifying gasfitters install hobs, cooktops, wall ovens and freestanding cookers across Wellington, the Hutt Valley, Porirua and the Kāpiti Coast. We check the supply, connect and test the appliance, and leave you with a gas certificate.
Gas cooktops and ovens in Lower Hutt: connecting to the network and fitting for the fault line
Most Lower Hutt kitchens are within reach of Powerco's natural gas network, which covers the Hutt Valley. Powerco says homes close to existing pipes can usually connect for free, and its address checker is the place to start. Once the supply is confirmed, we run pipe from the meter to the kitchen, fit an isolation valve where you can reach it, connect the cooktop or oven and test everything. If there is no main nearby, LPG works just as well for cooking, and many cooktops can run on either gas with the right jets. We confirm which gas you will use before you buy, so the right model and jets arrive.
Kitchen layout drives the job. Late-1940s state houses along the eastern side of the valley, from Waiwhetū to Taitā, were mostly built without gas, so the pipe usually runs under the floor from an outside meter. Newer homes in Normandale and Kelson on the western hills may already have gas at the kitchen and just need a straight swap. If you are renovating, we can rough in the gas line before the new cabinetry goes in. We check the clearances the maker sets between burners and rangehoods, side walls and benchtop edges, and confirm the kitchen has the ventilation the appliance needs.
Earthquake readiness is part of a good install here. The Wellington Fault forms the western edge of the valley, with its escarpment visible at Hutt Central School. Freestanding ovens should be fitted with the anti-tip bracket that comes with them, and we use an approved flexible connector so the appliance can move slightly in a shake without straining the gas line. After installation we test every burner, check flame picture and ignition, and leave you the certificate required for gas work.
Local tip: Ask for the gas isolation valve to be fitted where you can reach it without pulling the oven out, so you can shut it off quickly.
For anything else, see our plumbers in Lower Hutt.
Pricing: quotes are free, and every job gets a fixed price before we start, so there are no surprises on the invoice.
Gas Cooktops & Ovens Jobs We Do in Lower Hutt
- LPG cooktop conversions
- Gas cooktop installation
Gas Cooktops & Ovens Lower Hutt FAQs
Do I need to change my pipework to swap an electric oven for gas in Lower Hutt?
Yes. A gas oven needs a gas supply to the kitchen, so we run a new line from the meter or bottles, fit an isolation valve and test it before connecting the oven.
How much does it cost to install a gas hob in Wellington?
Moving the gas point or running new pipe costs more and is quoted first.
Do I need a rangehood over a gas hob?
A rangehood that vents outside is strongly recommended to remove combustion products and cooking fumes. Follow the clearances in the manufacturer's instructions.